Search results for "Biological Oxygen Demand Analysi"
showing 10 items of 26 documents
Effect of extended famine conditions on aerobic granular sludge stability in the treatment of brewery wastewater
2017
Results obtained from three aerobic granular sludge reactors treating brewery wastewater are presented. Reactors were operated for 60 d days in each of the two periods under different cycle duration: (Period I) short 6 h cycle, and (Period II) long 12 h cycle. Organic loading rates (OLR) varying from 0.7 kg COD m-3 d-1 to 4.1 kg COD m-3 d-1 were tested. During Period I, granules successfully developed in all reactors, however, results revealed that the feast and famine periods were not balanced and the granular structure deteriorated and became irregular. During Period II at decreased 12 h cycle time, granules were observed to develop again with superior structural stability compared to the…
Effect of additives on process stability of mesophilic anaerobic monodigestion of pig slaughterhouse waste
2012
The effect of two additives on anaerobic monodigestion of pig slaughterhouse waste was studied in three laboratory scale continuously stirred tank reactors (CSTRs) operated for 242-284 days at 35°C. A higher organic loading rate (OLR), namely 2.25 kg volatile solids (VS)/m(3)d with a hydraulic retention time (HRT) of 30 d was feasible with an additive containing Fe, HCl and trace elements while an OLR of 1.5 kg VS/m(3)d (HRT 30 d) led to instabilities in CSTR with an additive consisting of Fe and HCl and in CSTR without additives. Methane yields of ca. 700 dm(3) CH(4)/kg VS(fed) were obtained in all reactors under stable conditions. Both additives decreased H(2)S concentration of the biogas…
Pilot scale experiment with MBR operated in intermittent aeration condition: analysis of biological performance.
2014
The effect of intermittent aeration (IA) on a MBR system was investigated. The study was aimed at ana- lyzing different working conditions and the influence of different IA cycles on the biological performance of the MBR pilot plant, in terms of organic carbon and ammonium removal as well as extracellular poly- meric substances (EPSs) production. The membrane modules were placed in a separate compartment, continuously aerated. This configuration allowed to disconnect from the filtration stage the biological phenomena occurring into the IA bioreactor. The observed results highlighted good efficiencies, in terms of organic carbon and ammonium removal. It was noticed a significant soluble micr…
Experimental study of the anaerobic urban wastewater treatment in a submerged hollow-fibre membrane bioreactor at pilot scale
2011
The aim of this study was to assess the effect of several operational variables on both biological and separation process performance in a submerged anaerobic membrane bioreactor pilot plant that treats urban wastewater. The pilot plant is equipped with two industrial hollow-fibre ultrafiltration membrane modules (PURON¿ Koch Membrane Systems, 30m 2 of filtration surface each). It was operated under mesophilic conditions (at 33°C), 70days of SRT, and variable HRT ranging from 20 to 6h. The effects of the influent COD/SO 4-S ratio (ranging from 2 to 12) and the MLTS concentration (ranging from 6 to 22gL -1) were also analysed. The main performance results were about 87% of COD removal, efflu…
Refractory organic pollutants and toxicity in pulp and paper mill wastewaters
2015
This review describes medium and high molecular weight organic material found in wastewaters from pulp and paper industry. The aim is to review the versatile pollutants and the analysis methods for their determination. Among other pollutants, biocides, extractives, and lignin-derived compounds are major contributors to harmful effects, such as toxicity, of industrial wastewaters. Toxicity of wastewaters from pulp and paper mills is briefly evaluated including the methods for toxicity analyses. Traditionally, wastewater purification includes mechanical treatment followed by chemical and/or biological treatment processes. A variety of methods are available for the purification of industrial w…
Reliable method for assessing the COD mass balance of a submerged anaerobic membrane bioreactor (SAMBR) treating sulphate-rich municipal wastewater
2012
The anaerobic treatment of sulphate-rich wastewater causes sulphate reducing bacteria (SRB) and methanogenic archaea (MA) to compete for the available substrate. The outcome is lower methane yield coefficient and, therefore, a reduction in the energy recovery potential of the anaerobic treatment. Moreover, in order to assess the overall chemical oxygen demand (COD) balance, it is necessary to determine how much dissolved CH4 is lost in the effluent. The aim of this study is to develop a detailed and reliable method for assessing the COD mass balance and, thereby, to establish a more precise methane yield coefficient for anaerobic systems treating sulphate-rich wastewaters. A submerged anaer…
Two-stage anaerobic digestion of tomato, cucumber, common reed and grass silage in leach-bed reactors and upflow anaerobic sludge blanket reactors
2010
Abstract Anaerobic digestion of tomato, cucumber, common reed and grass silage was studied in four separate two-stage reactor configuration consisting of leach bed reactor (LBR) and upflow anaerobic sludge blanket reactor (UASB). LBR studies showed that COD solubilization for cucumber and grass silage was higher (50%) than tomato (35%) and common reed (15%). Results also showed that 31–39% of initial TKN present in tomato and cucumber was solubilized in the leachates and 47–54% of the solubilized TKN was converted to NH4-N. The corresponding values for common reed and grass silage were 38–50% and 18–36%, respectively. Biomethanation of the leachates in UASB reactors resulted in methane yiel…
Treatment of a submerged anaerobic membrane bioreactor (SAnMBR) effluent by an activated sludge system: the role of sulphide and thiosulphate in the …
2014
This work studies the use of a well-known and spread activated sludge system (UCT configuration) to treat the effluent of a submerged anaerobic membrane bioreactor (SAnMBR) treating domestic waste-water. Ammonia, phosphate, dissolved methane and sulphide concentrations in the SAnMBR effluent were around 55 mg NH4-N L-1, 7 mg PO4-P L-1, 30 mg non-methane biodegradable COD L-1, and 105 mg S2- L-1 respectively. The results showed a nitrification inhibition caused by the presence of sulphur compounds at any of the solids retention time (SRT) studied (15,20 and 25 days). This inhibition could be overcome increasing the hydraulic retention time (HRT) from 13 to 26 h. Among the sulphur compounds, …
Uncertainty and sensitivity analysis for reducing greenhouse gas emissions from wastewater treatment plants.
2020
Abstract This paper presents the sensitivity and uncertainty analysis of a plant-wide mathematical model for wastewater treatment plants (WWTPs). The mathematical model assesses direct and indirect (due to the energy consumption) greenhouse gases (GHG) emissions from a WWTP employing a whole-plant approach. The model includes: i) the kinetic/mass-balance based model regarding nitrogen; ii) two-step nitrification process; iii) N2O formation both during nitrification and denitrification (as dissolved and off-gas concentration). Important model factors have been selected by using the Extended-Fourier Amplitude Sensitivity Testing (FAST) global sensitivity analysis method. A scenario analysis h…
Effect of chemical and biological surfactants on activated sludge of MBR system: Microscopic analysis and foam test
2015
Abstract A bench-scale MBR unit was operated, under stressing condition, with the aim of stimulating the onset of foaming in the activated sludge. Possible synergies between synthetic surfactants in the wastewater and biological surfactants (Extra-Cellular Polymeric Substances, EPSs) were investigated by changing C/N ratio. The growth of filamentous bacteria was also discussed. The MBR unit provided satisfactory overall carbon removal overall efficiencies: in particular, synthetic surfactants were removed with efficiency higher than 90% and 95% for non-ionic and ionic surfactants, respectively. Lab investigation suggested also the importance to reduce synthetic surfactants presence entering…